Subject | Text |
Re: rca 46 inch again.... | [quote:73d50fc6d4="jloy1"]so in my previous post i had a high voltage arc from the center crt to the |
TV Problem | :D
I have a 32" Sony projection TV. Latley when I turn it on I am getting sound but no picture. |
|
re; RCA 195 | You didn`t say if the problem is with tuner input or video input ?
does the audio work at start up? |
| On the crt board you have 3 drives. Red, green, and blue. Check the voltage on each transistor. You |
Mitac LC-552 LCD Monitor | I have the same problem with this monitor
it seems to on but the screen is dark
maybe the psu ?
|
Mag 810FD too bright | A hand-me-down from a friend. The monitor is too bright and adjusting brightness and contrast can't |
| There really are so many variables to even attempt to guess at the problem... the guy who gave it to |
| Have been out of consumer electronics for some time...I used to see this problem on a regular bases |
philips lc 4341 projector | hi
has anyone come across the lamp driver assembly for this model,
have tried new bulb but get n |
tv sonic | bonjour
je recherche resoudre le probleme . le driver bu808dfi se chauf.
q.q un peut m'aidé e |
may be | may be this won't help but try yo unplug the tube ..clean pins and try again |
| Thanks madmatt2024 :idea:
I think you've given good suggestions & precautions, that's very |
| Hi G Money..
Are you conected to the correct terminal on the P.C.?? (Preferably "Line Out?")..If |
Re: Dead Hitachi | [quote:206ceea6a7="Stephen"]You should find the line driver, usualy located next to the HT transform |
| TCE CTC 187
NO HORIZONTAL SWEEP (CTC 187CL)
C4404 has probably blown up
Caused by an open C4403 |
philips l01.1e | hi all just wandering if some one could help me.?? i have a philips 32pw6006, it uses the L01.1e cha |
Philips 32pw6332 tv | Hi
Any help on service menu on Philips 32pw6332 i have shorted the 2 pins on left board and SER |
|
@Guest | @guest who recommends to replace all caps of the vertical driver unit
Okay, I agree that might be t |
| First, what is a LOPT? ” Totally dead with just the high pitched noise.” Horizontal out put transist |
TV Problem | Hello
I have a problem with a Wharfedale Model M8 "28-INCH CTV. Not coming on due to line oscilla |
SONY KV-28WS3E convergence | Hi,
I have a convergence problem with this tv , the chassis is AE-3
A green image (5cm) at the l |
Re: tv 770c schematic diagram | [quote:f53f313f29="darkest"]hello
casio tv 770c backlight problem fluorescent tube no light and n |
Re: Sony TV KV-35V76 ON and OFF picture | [quote="grizzley"]I have a Sony television Model KV35V76 where the picture is on for two seconds and |
| is the lopt transistor s/c again check for dry joints on the driver transformer and lopt stages |
Need a data sheet | Hi!Guys,i need data sheet suzuki alto 1000cc 2003 model odometer display driver ic,ic # is MG7372_42 |
| It,s always a good idea to resolder the line driver transformer pins after output transistor replace |
Dead Dell 1025HE | I'm attempting to repair a Dell 1025HE 17" monitor (essentially a Nokia 447S) for a friend.
sympt |
| Could you please email me service manual for a jvc 36" tube model AV-36985.
Thanks
p_dmoore@bbn. |
| You can't really see if it's bad. It's the big thing in the right hand corner with the red wire goin |
| Usually bad soldered joints, we 'call dry joints' that are dull Grey looking with cracks around the |